|
Initial Startup
When connected to the properly grounded power source, your EZe Control will turn on to the set temperature and count-down timer with one simple push of the On/Off button.
System On/Off
Push the On/Off button to start and stop a sauna session. A session will automatically end after the programmed timer expires.
Temperature Up and Temperature Down
Press either of the TEMP buttons to set the desired temperature. When the unit is not turned on and the UP temp button is pressed, this allows you to choose your programmed temperature. Press On/Off Button to ENTER number. (Holding down the buttons during programming allows quicker number changes on the LED monitor). * 115°F - 140°F recommended.
Press either UP or DOWN Temp buttons during sauna sessions to manually control desired heater output. (Automatically programmed temperature setting will resume on next session).
Session Time
Press the UP Time button while the system is off and the LED will blink. Use the Temp UP/DOWN buttons to set the desired session time. Press On/Off button to ENTER. Recommended 30 minutes a session.
Clock Setup
Press the DOWN Time button while the system is off and the LED will blink. Use the Time UP/DOWN buttons for the hour then press On/Off Button to ENTER. Then repeat the same for the minutes and press the On/Off Button to ENTER.
Light
Press the Light button to turn the inside light on and off. If you choose to leave the light on during the whole session, the light light will automatically turn off 10 minutes after your session is over.
| 
